The bleeding and venting valve SCF (EB 1.85)
is a combined start-up and continuous bleeding and venting valve with float control.
During start-up a large quantity of air is removed at low pressure via a large cone. If the ventilator is closed and further small quantities of air occur in continuous operation, an additional small seat opens and removes the air present. The large cone does not open until the level drops and pressure decreases at the same time. In the case of underpressure the valves open immediately. The minimum pressure for the valve seal is 0.2 bar.
The SCF (EB 1.85) is a float-controlled bleeding and venting valve for wastewater and sewage as well as for foaming media. An enlarged float housing prevents contact between the wastewater and the upper section of the closing mechanism.
The housings are made of spheroidal graphite iron with a continuous epoxy coating and are therefore outstandingly well protected. The valve cone is soft-sealed.
- Body made of spheroidal cast iron GJS 450-10
- Epoxy coating as per DVGW W270 and KTW recommendation of the German Ministry for Health, thickness min. 250 μm
- Internal parts made of 1.4301
- Float made of polypropylene PP
- Degassing bend made of polypropylene PP
- Highest flow rates thanks to "Full Bore" body design
- Pressure surge attentuation by anti-shock-system for closing smoothly and controlled
- Air discharge only
- Vacuum breaker version
venting up to 4100 Nm³/h
continuous bleeding up to 32 Nm³/h
- BMW
- Vattenfall
- Zweckverbände
- MIBRAG
- Skoda
- Sappi
- BASF
- Stadtwerke